Warm Audio DI Boxes allow you to run the high-impedance signals from guitar, bass, and keyboards directly into low impedance mic preamps, mixers, interfaces or to send signal over extended cable runs without losing volume, tone, and significant high-frequency information. Warm Audio's road-worthy DI Boxes are the professional solution for this common mismatch, ensuring you won't diminish the tone of your instrument or performance.
Popular Uses
- Direct Electric Guitars
- Direct Bass Signals
- Keys for Stage & Studio
- Direct, Clear Acoustic Guitar
Features
- The variable pad on the DI boxes is designed to help properly set levels from the DI to the mixer or audio interface. If distortion is audible, engage the bad and begin to apply attenuation until the signal is loud and clear.
- The “instrument” setting on the switch works with all types of instruments using ¼” outputs. When using a signal from a guitar amplifier is desired, switch to “amp out” switch to send your amplified guitar signal to the DI and then out via the XLR output. **
- The Phase switch reverses the polarity of the signal, correcting potentially poorly wired cables and eliminating phase-related noise issues.
- Eliminate noise like hum and buzz caused by ground-loop issues. As more pieces of equipment connect to various power supplies, the chance of ground-loop hum issues increase.
- Selectable active/passive switch to boost weaker signals
** WARNING: Most guitar amps require a reactive load (a speaker) to be connected to the amplifier to prevent overheating. The best practice is to connect a ¼” cable to the ‘THRU’ input directly to a properly rated speaker cabinet. This ensures the amp is loaded properly, preventing serious damage to your amplifier.
Tech Specs
-
Balanced Output: 600 Ohms, Mic Level
-
Input Impedance: 1 Meg Ohms
-
Active THD: .01% From 20 Hz To 50 Hz. Less than .003% From 50 Hz To 20 kHz
-
Active Frequency Response: 10 Hz To 90 kHz +/- 0.5db
